1、輸出壓力高：大液體輸出壓力可達400Mpa.
1. High output pressure: the output pressure of large liquid can reach 400MPa
2、適用范圍廣：工作介質可為液壓油，水及大部分化學腐蝕性液體，而且可靠性高，免維護和壽命長。
2. Wide application range: the working medium can be hydraulic oil, water and most chemical corrosive liquids, with high reliability, maintenance free and long service life.
3、輸出范圍廣：對所有型號泵僅需要較小氣壓就能平穩工作，此時獲得小流量，調節進氣量后可獲得不 同流量。
3. Wide output range: for all types of pumps, only a small air pressure is required to work stably. At this time, a small flow can be obtained. Different flows can be obtained after adjusting the air intake.
4、應用靈活：選用不同型號的泵，可獲得不同的壓力區域。
4. Flexible application: different types of pumps can obtain different pressure areas.
5、易于調節：在泵的壓力范圍內，調節調節閥從而調節輸入氣壓，輸出液壓得到調整
5. Easy to adjust: within the pressure range of the pump, adjust the regulating valve to adjust the input air pressure and the output hydraulic pressure
6、自動保壓：無論何種原因造成的保壓回路壓力下降，思宇泵都將自動啟動，補充泄露壓力，保持回路 壓力穩定。
6. Automatic pressure maintaining: the Siyu pump will start automatically to supplement the leakage pressure and maintain the stability of the circuit pressure no matter what the pressure drop of the pressure maintaining circuit is caused by.
7、操作：采用氣體驅動，無電弧及火花，可在危險場所使用
7. Operation safety: gas driven, no arc and spark, can be used in dangerous places
8、維護簡單：思宇泵能完成其他氣驅泵相同的工作，但其零件及密封少，維護簡單
8. Simple maintenance: Siyu pump can complete the same work as other gas drive pumps, but it has few parts and seals and simple maintenance
9、性價比高：思宇氣液增壓泵是一種柱塞泵，工作時思宇氣液增壓泵迅速往復工作，隨著輸出壓力增 高，泵的往復減慢直停止，此時泵輸出壓力恒定，能量消耗低，各部件停止運動。
9. High cost performance: Siyu gas-liquid booster pump is a plunger pump. When working, Siyu gas-liquid booster pump works back and forth rapidly. With the increase of output pressure, the reciprocating speed of the pump slows down until it stops. At this time, the pump output pressure is constant, the energy consumption is low, and all parts stop moving.
